Arduino Forum

Community => Exhibition / Gallery => Topic started by: Kuya Marc on Jan 29, 2011, 03:40 am

Title: My ADDICTION to building Atmel AVR/Arduino-compatible boards...
Post by: Kuya Marc on Jan 29, 2011, 03:40 am
Just using locally (Philippines) available parts, I've constructed 10 Atmel AVR microcontroller development boards, using stripboards. What is not pictured, is my 1st two Atmel AVR boards from ProtoStack (Australia).



And, believe it or not... I'm only doing this as a hobby...

Kuya Marc
Title: Re: My ADDICTION to building Atmel AVR/Arduino-compatible boards...
Post by: mowcius on Jan 29, 2011, 10:05 am

Just using locally (Philippines) available parts, I've constructed 10 Atmel AVR microcontroller development boards, using stripboards. What is not pictured, is my 1st two Atmel AVR boards from ProtoStack (Australia).



And, believe it or not... I'm only doing this as a hobby...

Kuya Marc


What do you do with them all? :D
Title: Re: My ADDICTION to building Atmel AVR/Arduino-compatible boards...
Post by: graynomad on Jan 29, 2011, 10:21 am
Man that shows some dedication.

______
Rob
Title: Re: My ADDICTION to building Atmel AVR/Arduino-compatible boards...
Post by: wossname on Jan 30, 2011, 07:37 pm
I like #10 with the zif socket, good thinking.
Title: Re: My ADDICTION to building Atmel AVR/Arduino-compatible boards...
Post by: stan001 on Feb 14, 2011, 11:49 am
I did a few of them on breadboard and uses the MAX232 and a USB-Serial converter... but it is kinda silly to convert the TTL from 5V to +/- 12V then back to 5V again...

I tried looking for the Nokia CA-42 locally at mobile phone shops...

Most of the shops give me a strange look... later I found out only very old Nokia models uses CA-42 cables...

End up using the DFR's FTDI Breakout board... would like a DIP version of USB-TTL but most of the USB-TTL are all surface mount chips..