Hi all, Here is my home designed controller based on the Attiny 85, Programmed with the arduino IDE. Pin headers are as follows :
6 Pin ISP
8 +5v connections (Outside row)
8 0v connections (Middle row)
Inside row is left to right - RESET | +5 | GND | D0 | D1 | D2 | D3 | D4
(uCONTROLLER PINS : 1 | 8 | 4 | 5 | 6 | 7 | 2 | 3 )
Currently used as a controller for my robotics projects.
Available to buy if anyone interested.
Contact me via PM or via email : email@example.com
LOL - was updating when you posted - all done.
violet is cool
Pretty neat! Any documentations to go with it? What lib would work what would not? Frequency, SRAM, FLASH, EEPROM etc. Also cost of the entire board?
Hi - Board is £3.00 GBP - Headers, chip socket, led & resistor is about £2.00 GBP (of course you can source your own components) - Add your own Micro-controller e.g. Attiny 13, 45, 85 (the only ones I tested - 1k, 4k and 8k). Using the Core files found here : http://hlt.media.mit.edu/wiki/pmwiki.php?n=Main.ArduinoATtiny4585 (http://hlt.media.mit.edu/wiki/pmwiki.php?n=Main.ArduinoATtiny4585).
The specification for the controllers can be found here : http://www.atmel.com/dyn/products/documents.asp?category_id=163&family_id=607&subfamily_id=791 (http://www.atmel.com/dyn/products/documents.asp?category_id=163&family_id=607&subfamily_id=791)
Set the fuses for internal Oscillator - 8Mhz. H-DD L-E2 E-FF No lock /bits
Excludes P&P - Sent at Cost
Anyone Interested? Only got 4 left. Available as bare board or full kit (excluding uController).
PM me or email me : firstname.lastname@example.org (http://email@example.com)