Arduino Forum

Forum 2005-2010 (read only) => Software => Bugs & Suggestions => Topic started by: ajmas on Oct 18, 2008, 03:30 pm

Title: IPv6 support?
Post by: ajmas on Oct 18, 2008, 03:30 pm
Are there any plans for IPv6 support? Has anyone looked into this?
Title: Re: IPv6 support?
Post by: westfw on Oct 21, 2008, 05:02 pm
Um, is there even IPv4 support in the current code?  ANY networking support?
Title: Re: IPv6 support?
Post by: mem on Oct 21, 2008, 05:16 pm
Perhaps tamarok means the Ethernet library for the W5100 in the latest arduino distribution. I don't think the W5100 supports ipv6 yet
Title: Re: IPv6 support?
Post by: ghoelzl on Mar 14, 2010, 09:22 am
At the moment the only way to get IPv6 working on Arduino is to use ENC28J60 based Ethernet shields or an XPORT PRO from Lantronix.
Title: Re: IPv6 support?
Post by: ghoelzl on Mar 23, 2010, 09:03 pm
I ported the uipv6 stack to Arduino, see http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1268555095
Title: Re: IPv6 support?
Post by: westfw on Mar 24, 2010, 10:39 am
Doesn't the wiznet chip support a "mac raw" mode that could theoretically support IPv6 (or anything else, perhaps including a SW IPv4 stack)?  The documentation is pretty sketchy, and I haven't looked for more...