Go Down

Topic: Logging gyro output (Read 5788 times) previous topic - next topic


Hi Everyone

I am planning to build a rate table, and need to log the gyro output.
I think it is best to log the table rpm and gyro output onto an SD card. Any suggestions?
Is it better to use I2C or SPI for communication between the table,gyro to the Arduino board?

Has anyone used following  shield?



From the outside it looks ok, but no experience. I do have worked with - http://www.ladyada.net/make/logshield/index.html - and it worked like a charm, sorry works like a charm as it still functions great.

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)


Thanks Rob

I guess, i will use the ladyAda one then. Did you buy it from them or put it together yourself?
I need the Arduino pins A4 and A5 for I2c communication with the Gyro.
Could you confirm if those pins are free on the shield?
How can you tell by looking at the sketch? I am new to diy electronics, hence the stupid questions


Go Up