Installation & Troubleshooting
Topic: Bootloader Problem?
(Read 590 times)
Jul 30, 2013, 06:23 pm
I'm having an issue with an Arduino Leo + Ethernet Shield. When powered off and powered back on, it seems that my sketch is not being re-uploaded to the board. Same issue happens when pressing the reset button.
Note that my sketch is 24k out of 28k so it is relatively large, if this helps at all.
Is it a problem with the bootloader?
Re: Bootloader Problem?
Jul 31, 2013, 12:48 am
What do you mean, re-uploaded?
Once uploaded it stays there.
Please post technical questions on the forum, not by personal message. Thanks!
More info: http://www.gammon.com.au/electronics