Go Down

Topic: Controling a 9v supplied CMOS with Arduino's 5v (Read 8833 times) previous topic - next topic


The pins are comparable to say 20K resistors. The 100K resistor will limit the current from the 9V source to 0.09mA, so the output would be like 1.8, so that could be okay.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.


OK this is almost working......but I'm only getting 5.5v at the gate? I guess the 100k  pullup resistor is to big? How low can I make the pullup resistor to get more voltage but not harm the Arduino pin?

Soooooooooooooo close!

Go Up