Hi,
I started again from scratch.
I changed in the source code "DataDisplay2":
[ Code]#define N2k_CAN_INT_PIN 21 [ /Code]
with that the:
[ Code]#define N2k_CAN_INT_PIN 2[ /Code]
and added the line:
[ /Code]#define N2k_SPI_CS_PIN 10[ /Code]
I always have the message:
"CAN device ready
Running ... "
I tested with a multimeter where are "cs" and "int".
I am sure that:
cs = 10
int = 2
I don't think see any resistance on CANH and CANL pin, I transmitted you the electrical diagram.
https://drive.google.com/open?id=1pSLUZES1smCzmFGpnB2YTR5_A15GZBnr
Now what i need to do ?
Thank you a lot.