Go Down

Topic: Please help me-----Port Problem (Read 554 times) previous topic - next topic

AEKurekci

Hello everbody

I new started to work on arduino yesterday(actually I could not start yet). But I cannot send command to the arduino board. The arduino is klon onethat is mega 2560 and the problem is I think port.

I want to show you the command and the error.

Code: [Select]



void setup() {
  // put your setup code here, to run once:
Serial.begin(9600);
}

void loop() {
  // put your main code here, to run repeatedly:
Serial.println("Hello World!");
delay(1000);
}



Arduino:1.8.5 (Windows 10), Kart:"Arduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)"

Çalışmanız programın 1944 bayt (0 %) saklama alanını kullandı. Maksimum 253952 bayt.
Global değişkenler belleğin 200 byte kadarını  (2%) kullanıyor. Yerel değişkenler için 7992 byte yer kalıyor. En fazla 8192 byte kullanılabilir.
avrdude: ser_open(): can't set com-state for "\\.\COM4"
avrdude: ser_drain(): read error: İşleyici geçersiz.


avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: İşleyici geçersiz.


avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: İşleyici geçersiz.


avrdude: stk500v2_ReceiveMessage(): timeout
Seçilen seri port "
" bağlı olan kartınızda mevcut değil
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: İşleyici geçersiz.


avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: İşleyici geçersiz.


avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: İşleyici geçersiz.


avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: ser_send(): write error: sorry no info avail
avrdude: stk500_send(): failed to send command to serial port
avrdude: ser_recv(): read error: İşleyici geçersiz.


avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_getsync(): timeout communicating with programmer

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.


I really need your help.

I tried to change port but I got same result.
I chosed->tools->COM4
I restarted again and again it didn't change.



AEKurekci

The Problem is solved I had needed to set up driver for clon. The site that I downloaded driver is that;

http://maker.robotistan.com/arduino-uno-suruculeri-nasil-yuklenir-ch340-cipli-klon/


Go Up