Go Down

Topic: Pro Micro Bricked? (Read 193 times) previous topic - next topic

x9Memoriez

Hey guys, new to the forum.

So im actually trying to flash a .hex file onto a pro micro currently soldered onto a keyboard PCB, however midway through the flash using AVRDUDES, the pro micro 'stopped responding' according to the software.

After that, the previous solid red light on the end of the pro micro turned off, and now no longer turns back on, no matter what cable, port, or computer is used.

No computer can detect the pro micro, and shorting the reset/ground pins does nothing as i can see.

There is only a solid green light visible when its plugged into power, however that's it.

Have i bricked the pro micro? How would i get that red light back/allow it to be detected and flashed again?

Would definitely rather fix this one than replace it, as desolding it is a pain.

Cheers guys.

Go Up