Education and Teaching
(Read 854 times)
Sep 23, 2018, 12:00 pm
I've been working on an Attiny85 project and am trying to program the microcontroller using WinAVR and Burn-O-Mat to burn the code onto the chip.
After i plug the chip to the arduino ISP and try to read the fuse bits using Burn-O-Mat, I see all the bits HIGH for all three of my Attiny85 chips and am unable to write over them with the default fuse bits, the application says error writing fuses.
I have bought one of the attinys from the market and got this problem with that one at first, so I thought I had bricked it somehow or it was bricked to being with. So then I ordered two more from amazon and when I tried to read their fuse bits, again, all the bits were marked/HIGH.
How can I rewrite fuse bits?
Are these chips bricked?
Am I using the Burn-O-Mat wrong?
What else could be the issue?
Apr 02, 2019, 07:09 pm
: Apr 02, 2019, 07:16 pm by GolamMostafa
If you are still tracking your thread/post, please visit
to get a solution to your problem with regards to fuse bits of ATtiny85 MCU.