Go Down

Topic: Arduino Yun Error message (Read 279 times) previous topic - next topic


So, I just got this brand new Arduino Yun Rev 2, I followed the instructions on how to use it and configuring the yun

I hop into the Arduino IDE, open the "Blink" sketch Press "Upload" get a GUI that says I have to type in the board password, i type it but then i get an error...(from the output)

   at cc.arduino.packages.uploaders.SSHUploader.uploadUsingPreferences(SSHUploader.java:145)
   at cc.arduino.UploaderUtils.upload(UploaderUtils.java:77)
   at processing.app.SketchController.upload(SketchController.java:732)
   at processing.app.SketchController.exportApplet(SketchController.java:703)
   at processing.app.Editor$UploadHandler.run(Editor.java:2042)
   at java.lang.Thread.run(Thread.java:748)
Caused by: com.jcraft.jsch.JSchException: java.net.ConnectException: Connection timed out: connect
   at com.jcraft.jsch.Util.createSocket(Util.java:389)
   at com.jcraft.jsch.Session.connect(Session.java:215)
   at cc.arduino.packages.uploaders.SSHUploader.uploadUsingPreferences(SSHUploader.java:117)
   ... 5 more

Go Up