Go Down

Topic: 72.5 full rotation of servomotor (ready to pay) (Read 295 times) previous topic - next topic

Jomana_A

Hi everyone


I need to program my servomotor to rotate 72.5 full rotation with step angle 73 degree, and when that is done the motor should stop.

I'm ready to pay for the code, you can contact me via this email j.m.n.h@hotmail.com

johnwasser

You are not going to get code until you add a way to sense the rotation of your "continuous rotation servo".

This rotary encoder from eBay might be suitable:
https://www.ebay.com/p/Aideepen-Encoder-600-P-R-5v-24v-Incremental-Rotary-AB-2-Phase-6mm-Shaft/19011022356?iid=372495625303&chn=ps
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp

cedarlakeinstruments

72.5 rotations is 900 degrees. Taking 73 degree increments is 12.3 moves. What do you want to do with the additional 21.9 degrees left over?
Electronics and firmware/software design and assistance. No project too small

PaulS

Quote
72.5 rotations is 900 degrees.
Your calculator needs new batteries.
The art of getting good answers lies in asking good questions.

Go Up