Go Down

Topic: Issue from the tachometer (Self balancing motorcycle) (Read 345 times) previous topic - next topic

Yami89

I'm having issue of getting any reading on the scope from the tachometer. I have double checked the connections, tried the test codes provided in the project files. No luck :( . I came across an old thread describing the same behavior. https://forum.arduino.cc/index.php?topic=573317.0


Anyone else faced the same issue if so what was the solution?. I am hoping that its not a busted tachometer - I did check it  right after unboxing the kit, it worked then.

Thanks in advance

p.s: The led on the tachometer board is on, so its not completely dead.

Julian_ortiz_olaya

#1
May 22, 2019, 04:23 pm Last Edit: May 22, 2019, 04:24 pm by Julian_ortiz_olaya
Hello

I have similar issue but my tachometer don't have any led on it, issue was because tachometer is far from the inertia wheel, try to bring near wheel to tachometer.

Go Up