Go Down

Topic: Setting washer default value selection (Read 352 times) previous topic - next topic

azmanyu

Apr 11, 2019, 01:19 am Last Edit: Apr 11, 2019, 01:23 am by azmanyu
i plan to have an anduino to control the operation of a small washer.  I've figured out how to get the washer status to the arduino.  However for my purpose,  the washer default operational option need to set to a certain value.  for my case the washer option should set to "quick".  

So my question is what is the best way to set the washer default value.  do i have to do some soldering and jumpering on the washer switch?  if so appreciate if you could share some tips on how to do about it

thanks in advance

Paul_KD7HB

i plan to have an anduino to control the operation of a small washer.  I've figured out how to get the washer status to the arduino.  However for my purpose,  the washer default operational option need to set to a certain value.  for my case the washer option should set to "quick". 

So my question is what is the best way to set the washer default value.  do i have to do some soldering and jumpering on the washer switch?  if so appreciate if you could share some tips on how to do about it

thanks in advance
If you sent this posting to your Grandmother, would she know what you are writing about? Neither do I .

Paul

wvmarle

Based on the generous amount of info given (especially on the exact type of "washer" and what you're planning to do with it) I think you best refer to the device's manual. That will have more answers available than we have here.
Quality of answers is related to the quality of questions. Good questions will get good answers. Useless answers are a sign of a poor question.

Go Up