Go Down

Topic: Arduino/LabView doesn´t work (Read 337 times) previous topic - next topic

lacorca

Hello,
I´m trying to control Arduino with LabView. I have Arduino Uno, Labview 2014 32bit, and the PC is Windows 10 64bit. I have installed VI Package Manager and NI-VISA 2017 drivers.
When I upload the LIFA_BASE code, the upload is done but the console gives some warnings.
But, when I run any example in LabView, nothing happens… I try, for example, to turn on a led with the blink example, and the led is always off...
What could be happened? Are this drivers good for this LabView?
Thank you for your attention and please help me!!

ieee488

Arduino with LabVIEW most certainly work.
I have it.
And I don't even use LIFA or its successor LINX.

lacorca

#2
Apr 12, 2019, 10:52 am Last Edit: Apr 12, 2019, 10:56 am by lacorca
In my case, with LIFA, doesn´t work.
When I use it without LIFA, it works, but it´s very difficult to me because I´m a beginner, so I prefer use LIFA.

ieee488

LIFA is depracated.
LINX is the successor.

Go Up