Go Down

Topic: using milling to delay and control two color sensors and two servo motors  (Read 65 times) previous topic - next topic

ChristophTorres

hi, I need help so basically, I have been trying to work on a code  that would allow souring 2 different colors of balls  in two different locations meaning one color sensor and servo motor in a different location than the other ones, and I was thinking about just using Millis because I need the balls to get release or move by the servos in one second interval per ball.
 
I also know that I need a battery attached to the board in order to not overworked the Arduino.

this my first time using Arduino so anything can help.

thank you in advance.

UKHeliBob

Please do not send me PMs asking for help.  Post in the forum then everyone will benefit from seeing the questions and answers.

PaulS

Quote
that would allow souring 2 different colors of balls
How, EXACTLY, is the Arduino supposed to sour a ball? Inquiring minds want to know.
The art of getting good answers lies in asking good questions.

Go Up