Go Down

Topic: dfu programming (Read 657 times) previous topic - next topic

spinsycle

Im trying to build a midi controller with a arduino uno.  im looking at the directions for updating the firmware.  it says if you have a non smd uno you need to solder on a resistor.  I can do that but the picture shows an arduino uno and i have and arduino uno r2.  the traces look different so im not sure where to solder the resistor.  any help would be really appreciated.

Razorblade

If your Uno is a R2, you must follow SMD steps. So you don't need to solder anything.

spinsycle

Thank you!!!!  I appreciate the quick response.

Go Up