Go Down

Topic: How to control 3 servo motors with the UNO (Read 33831 times) previous topic - next topic


je viens de faire un programme arduino pour un servo de type  ACE R/C DS1015 mais je trouve pas son largeur d'impulsion pour commancer le programme...
px vous m'aider et merci



Hi guys,
This is my first time that I read about Arduino as a controller of servomotor, thus I am fully new on this world.
My inquiry is "Can I control a group of servomotors respectively (one after another)?"
Thank you.


Yes. You should read the Servo webpage in the Learning section.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up