Go Down

Topic: Esplora power hack (Read 2938 times) previous topic - next topic


Jan 18, 2013, 06:12 pm Last Edit: Jan 19, 2013, 06:01 pm by TheKitty Reason: 1
The Esplora was not really designed for battery power.  In the last two weeks I have used an Energizer "cell phone" backup battery into the USB port.

The more elegant (hack) solution is using a rechargeable LiPo battery. But this will not put out the 5 volts the Esplora needs.  This is where an Adafruit Mintyboost works well to boost the 3.6 volts from the battery circuit boosts to 5 volts.

To feed the voltage in, I put it into the Tinkerkit output pins rather than the USB to create a lower profile and free the port for programming.  Be careful not to have both connected at the same time.

Full details on how this was done are at http://21stdigitalhome.blogspot.com/2013/01/lipo-powered-arduino-esplora-game.html.

The project also adds an XBee radio that communicates via the two Tinkerkit digital pins which map to Arduino IDE digital pins 3 and 11.  The only two free pins to hack around with if you use a display.  I've documented the display interface if you want to hack those pins, see http://21stdigitalhome.blogspot.com/ under December.


cross-post with - http://arduino.cc/forum/index.php/topic,143371.msg1076748.html#msg1076748 -

Please remove one of the threads. (advice keep the other with the pictures, they look good!)
Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

Go Up