Go Down

Topic: Tower pro SG 5010 servo current (Read 1 time) previous topic - next topic


I have been powering a hobby servo from an Arduino but want to use an external source - a wall wart, 8v/500mA regulated with a 7806. This fails to run the servo. Nor does a 9v battery. I've read that these typically need as much as one amp each.  The project needs three. Any ideas?


If the servo is under load, it may take 1a or more. 
Google forum search: Use Google Search box in upper right side of this page.
Why I like my 2005 Rio Yellow Honda S2000  https://www.youtube.com/watch?v=pWjMvrkUqX0

Go Up