Go Down

Topic: Do I need to use a motor shield to activate a 12 VDC linear actuator? (Read 1 time) previous topic - next topic


Do I need to use a motor shield to activate 2 12VDC linear actuators or can I just plug them into the arduino duemilinova? I am new to arduino so Im not really experienced with this.
The actuator uses a DC motor and is created by Firgelli Auto

Here is the link for the actuator... http://www.firgelliauto.com/product_info.php?cPath=69&products_id=248

Also, how would i rig this up when using an external power source?


Don't cross post please.
Have a look at "blink without delay".
Did you connect the grounds ?
Je kunt hier ook in het Nederlands terecht: http://arduino.cc/forum/index.php/board,77.0.html


Link you provided says the motor can draw up to 10 A, so you can't power it directly from Arduino. Your options are either a motor shield which can provide that current for both actuators at the same time, an off the shelf motor driver, or a custom built H bridge.


It seems that it is a voltage device, ie, if you apply 12VDC it will react. But since it draws a lot of current, you will definitely need a power MOSFET to actuate it. Make sure your power supply can supply enough current it draws, otherwise you will have an unstable system.

Go Up