Go Down

Topic: Jumper wire connection between Seeeduino V3 and UartSbee v.4 (Read 730 times) previous topic - next topic

peper

How do I communicate Seeeduino v3 to Uartsbee v4 by using jumper wire cable?
the problem is seeeduino v3 didnt have uartsbee header, so I've been wondering how do i wire them
any advice would be great, thankyou

PaulS

The minimum connections needed are Gnd, VCC, TX, and RX.

Which pins on the Arduino-clone you connect RX and TX to depends on whether you plan to use SoftwareSerial, AltSoftSerial, etc. instance or a HardwareSerial instance to read from/write to the XBee.
The art of getting good answers lies in asking good questions.

Go Up