Go Down

Topic: Arduino Uno with M5100B-D GSM Shield network connection (Read 2876 times) previous topic - next topic


Hi All.
This is bumped from the networking forum and I have added the updates.

I am new to working with Arduinos and prototyping and I am having difficulty with a project I have committed myself to. A bit of background: The project is intended to use my Arduino Uno with an GSM shield to triangulate location at frequent and repeating intervals. So far I have the hardware set up and working to a stage of two way communication between my computer and the shield. Upon activation I receive:

Starting SM5100B Communication...
+SIND: 0

+SIND: 10,"SM",0,"FD",0,"LD",0,"MC",0,"RC",0,"ME",0

+SIND: 8

After doing some research I have established that this means I am not properly connected to the cell tower network (makes sense, since I cannot retrieve information about the network or connected cellids). My attempt at a resolution was to change the frequency on which the shield was recieving by commanding:


This was intended to change the frequency to the correct range, given by my service provider. This has not proven successful and I am reaching out for help to anyone who may be more versed with this stuff. (so far I have been following the guidance prescribed at this blog: http://tronixstuff.wordpress.com/2011/01/19/tutorial-arduino-and-gsm-cellular-part-one/)

The hardware I have installed are listed below:
1. Arduino Uno
2. Spreadtrum communications INC. model number M5100B-D
3. an attached antenna,
4. 9V direct AC power supply
6. Vergin Mobile Sim Card LTE

Thank you for your help!!

- Jff-M


The connection +Sband: 0 indicates the sim card is not inserted. There is a connection error between my Vergin Mobile Sim card and the shield. Could anyone confirm this issue or a workaround?



See http://arduino.cc/forum/index.php/topic,158163.0.html

Go Up