Go Down

Topic: Laser trigger for Canon camera (Read 2583 times) previous topic - next topic

gregmcc

Nov 02, 2013, 09:42 pm Last Edit: Nov 03, 2013, 08:59 am by GregM Reason: 1
I build this project so I could setup my camera to take pictures of water drops.

This was built on a Arduino and then transferred to a veroboard.

The circuit uses a laser diode with a LM317 setup as a current limiter. A LDR is connected to the Arduino's analogue pin and triggers the camera shutter when the laser shining on the LDR is triggered.

The trigger allows you to set the delay time for the trigger by means of 2 switches and the delay is displayed on 2 x 7 Segment Displays (driven by 2 x 74HC595 shift registers)

Check out my blog for the complete project and source code.

http://blog.gjmccarthy.co.uk/?p=345

Chagrin

A phototransistor or photodiode would be better than an LDR. I'd imagine that you're seeing a very slight analog reading change when the drop passes the LDR; this is because of the slow response times of LDRs.

gregmcc

Actually its quite a drop.  When the laser is on the LDR its around 700 analogue reading. When its not on its about 300.

Go Up