In a kickstarter project the same discussion ended with that solution:https://www.kickstarter.com/projects/214379695/micro-python-python-for-microcontrollers/posts/727834
mounting holes. These would increase the size of the board by 30%
re: Mounting Holes How about one bolt hole near the center, can you squeeze that in?
Wow. Awesome video! One small foot-step for eMotorWerknstein, one giant leap for the Arduino Due based-kind!p
1. is CAN termination resistor (120R) needed on this board? If it's connected to fully configured CAN bus, one would have to desolder 0402 part from the board...2. As you saw in the video (https://www.youtube.com/watch?v=kPL8APZyh4A), the idea is to have a separate landing board in the UNO format. That board would provide micro-USB connection, ability to power from 7-12V source, etc. The question is what else we should provide on that board. For now, we have added a second CAN tranceiver - after all, most of our own uses will be automotive-related. What else?3. If you were really paying attention to the video, you could spot a few MicroShields on the PCB array. At the moment, we have a WiFi MicroShield and a LCD MicroShield. What else could be interesting?
P - I have read your thread on ETH in its entirety a few days ago. You are doing truly amazing work for the community (ETH, CAN, etc...).Sadly I can't figure out sourcing for DM9161 chip...