Go Down

Topic: Will a shield built fo mega snap on mega 2560 (Read 1 time) previous topic - next topic


Here is the shield http://www.dx.com/p/openjumper-mega-extension-board-w-mini-bread-for-arduino-red-works-with-official-arduino-boards-285977#.U1QD2_ldX_o



It doens't connect to the ISCP connector, because it doesn't have the mating connector.
But the other ones all seem to be there.
It also has a field of 2 * 6 solder pads, like the ICSP.
I can't tell for sure but it is possible that this leads to the same pins as the ICSP connector.
But if you have no need for that connector, it'll be fine.
Have a look at "blink without delay".
Did you connect the grounds ?
Je kunt hier ook in het Nederlands terecht: http://arduino.cc/forum/index.php/board,77.0.html

Go Up