No billpealer I must the dummest since I bought a pic chip programmer instead of the wt588d sound board programmer. So now I have to order the proper one which sets me back a week or two since it is coming from China. Duuh
hey billpealer could you tell which pins you used on your momentary switch. mine has 8 and only figured out that 2 are for the led. i even tried to find a spec sheet for mine and came up with nothing. i even got it from tcss
thanks i will do that... but i think i ran into another snag... 16mm switches are too long for my hilt so i need to get the short ones for this one... well part of making a prototype. i will use the long ones in my next hilt. waste not want not... thanks again billpealer. half of says stop now and give up but the other half says must keep going it can be done... etcetera.
<tentatively puts hand up> um, would it be hard to make a switch box like this?I've been looking at getting a custom button box master part made from alu as I have some billets. I was then going to take a mould and make cold casts using different metals such as cobalt, titanium, chromium etc, or just plain black resin depending on the hilt but the cheapest quote I've had is £200 for the one part