Go Down

Topic: CAN BUS (Read 401 times) previous topic - next topic

xinfinite

Hi,

I want to connect several Arduino's using the CAN BUS protocol.
One MCP2515 and more MCP2551.

Is this possible?
If so, how do I use the CANH CANL signal in a slave Arduino?

TIA

xinfinite

I found this:

http://electronics.stackexchange.com/questions/106715/is-the-can-bus-protocol-a-master-and-slave-protocol

There are no slaves!
So it isn't good for my project.
I need something else then SPI on the 'slave' side!

Go Up