Go Down

Topic: Who has the Slic3r config settings for a Arduino Materia 101 Kit - Slicer ini (Read 3802 times) previous topic - next topic

botberg

Hi,

I received my 101 Kit earlier this week. After some hours I was able to make it work. While reading through the manual (http://arduino.cc/en/uploads/Main/Materia101_User_Manual_EN_rev4.pdf) I found at page 25 that '.... In order to simplify the process, these are made available on the arduino web page.'

So far I wasn't able to find this config file at the Arduino web site.
If any has this file (there was no software in my Materia 101 kit), I would appriciate it very much to receive this config file... or a dump of the settings.

Regards,


Bas.
Netherlands.

robtillaart

Couldn't find it either but found two sites, possibly interesting (maybe to contact them)

- https://github.com/alexrj/Slic3r -

- http://scuola.arduino.cc/lesson/8Jr4mKq/Getting_to_know_the_Materia_101_Your_first_print -

This latter is completely new to me....
Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

robtillaart


bingo?

- https://github.com/radandre/MATERIA101/tree/master/Slic3r%20Profile -

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

botberg


kengdahl

Thank you Rob   :)

I also just updated the sticky with these settings.

robtillaart

you better call it MATERIA-FAQ I think, in the most fora "read me first" is interpreted as "skip this" ;)

and formulate short questions (bold) with a short answer or a link to an answer or  a "don't know"

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

Go Up