Go Down

Topic: Arduino pinout/mosfet issue (Read 309 times) previous topic - next topic

windoze_killa

The one you listed will work fine at 12V. That is just the switched side. Also if you want something a bit smaller try this.

http://www.farnell.com/datasheets/2243603.pdf
Engineers design things.....technicians make them work.

Paul__B

Measure the current of both leds by measuring the voltage across them and dividing by the resistor value and I believe you will find the mosfet driven led is drawing less current.
Measure the current ... by measuring the voltage across the resistor and dividing by the resistor value

raschemmel

I might have been have typed that on my phone in haste...
You knew what I meant and the OP never did it
anyway so I guess nothibgl lost...

Go Up