Go Down

Topic: interfacing arduino uno to GSM SmartSIM340z problems (Read 731 times) previous topic - next topic

addula123

i need the full interfacing method from you between arduino uno and GSM smart sim340z , also if you can detai as much as you you can , please provide the testing code for modem with the UNO micro controller .



note : what i have done is that i connected :

pin 0 to the tx of modem
pin 1 to the rx of the modem

i connect the Vcc and GND of the modem to the UNO board with 5v
i provided  9v dc to the modem
the SIM registered on network  but when testin the modem with modem tsting code on arduino it dont respond

stoutfiles

How much are you paying for someone to write the code for you?

addula123

as much as you are sure that your code with the connection you will support  will work in my project

stoutfiles

You have it connected right I believe; I'm not sure what to tell you.  I found no code specifically written for an Arduino, but this is going to be your closest match.

http://www.mikroe.com/downloads/get/382/sim340z_avr_examples_v100.zip

If I had to suggest an option, I would get something dedicated to Arduino.  I'm a big fan of the Adafruit FONA myself, or the Arduino GSM Shield if you're ok with expired products, or something else.

Go Up