Hi there, I am using DRV8825 stepper drivers (3 of) to control 2A motors.
They are wired up as so...
http://mchobby.be/wiki/index.php?title=DRV8825(it shows how the wiring is done about half way down the page)
with the Enable pin attached to a pin but LOW when in use.
I pulled the enable pin of two of the drivers and now they seem to not work even when the enable pin is connected again? (and it was set to LOW anyway)
I know the code is okay because it was working previously, it is just a slightly adapted version of that shown on the webpage.
Does anyone have any advice on how to get this working again or have I destroyed the DRV8825 drivers?
Thanks, Mark