Go Down

Topic: Servo! Help me!  (Read 963 times) previous topic - next topic

SIEVEPRIMESAXON

Hey guys!

I am struggling to make my servo work. The servo is connected to an external power source, and it is connected to pin 9. I am using the code from the example, "Sweep". The port and board choice are all right. I'm using an Arduino Uno. Please help me!! I have been stuck for hours!!!

zoomkat

Quote
The servo is connected to an external power source, and it is connected to pin 9.
Do you have the servo ground, arduino ground, and external power supply ground connected together?
Google forum search: Use Google Search box in upper right side of this page.
Why I like my 2005 Rio Yellow Honda S2000  https://www.youtube.com/watch?v=pWjMvrkUqX0

SIEVEPRIMESAXON

Umm..... no. Let me try.

SIEVEPRIMESAXON


SIEVEPRIMESAXON

All right! I got it to work! Thanks!

MarkT

Did you not try looking on Google for how to wire a servo?
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

SIEVEPRIMESAXON

I did. However, some of the things that I read on Google were a bit misleading.

eXXonWaldez

Always double check that you read on internet. Use at least two sources. That will help for time and safety.

Regards.

Go Up