Go Down

Topic: Bare Bones Datalogging (UPDATE) (Read 3893 times) previous topic - next topic

Seedler

Hi  folks,

Me again.  I have had another attempt at making this board.  This time I verified all my positives and negatives before connecting the programmer.  I also verified that all connections to MISO, MOSI SCK and reset were correct.  All pads on the chip have a connection back to the programmer, and I have also made sure there were no bridges between pads.

But I still cant burn a bootloader.  I get the same errors as last time.  I reflowed at 250 deg, so I'm sure I didn't fry anything.

I'm totally stumped.  I don't know where to go from here.  Does anyone have any ideas?

Thanks.

Damien

Go Up