Go Down

Topic: Relocation of atmel chip on the arduino (Read 361 times) previous topic - next topic

Obuye

Is it possible to remove an atmel chip that has been programed via the arduino board and use it on another circuit board and still have it working?

TomGeorge

Hi,
Yes, you need to have the basic 5V supply and crystal and caps to run it
Google    bareduino   or minimum arduino hardware

I have used a bareduino kit, programmed the 20pin IC in the arduino UNO then plugged it into a prototype board with the bare essentials.

Tom.... :)
Everything runs on smoke, let the smoke out, it stops running....

TomGeorge

Hi,
I've also set one up using ICSP, no problems.

Tom.... :)
Everything runs on smoke, let the smoke out, it stops running....

groundFungus

#3
Nov 10, 2015, 01:00 pm Last Edit: Nov 10, 2015, 01:01 pm by groundfungus
Bare bones Arduino  Nick Gammon stand alone 328  Programming a Mega328 in a breadboard.

Go Up