Go Down

Topic: Use ATMEL ICE with Arduino Zero to change fuses? (Read 500 times) previous topic - next topic

sandisk1duo

Hello,

I want to mess with the fuses on my Arduino Zero. (Yes, I know I could brick it, but I am willing to take the risk).
Anyways, I went through a bunch of trouble to solder an appropriate header to my Arduino Zero so that I could connect it to my Atmel ICE. When reading the chip I AVR Studio tells me that the device signature is 0x10010205. The appropriate signature should be 0x1001000f (at least that's what AVR Studio tells me). Because of this, I cannot mess with Fuses.

Debugging steps.
1. Checked if the header is soldered properly (it is)
2. Changed the AVR ICE programming frequency to 324KHz and 2MHz, still nothing.

I was wondering if anyone else is having similar problems?

Thank you In advance!  :)

Go Up