I'm using Macbook with Arduino IDE 1.6.8 and Intel Curie board 1.0.6Try to upload sketch and got this error...Flashing is taking longer than expectedTry pressing MASTER_RESET buttonERROR: Device is not responding.Device is not responding, check the right serial port is selected or RESET the board right before exporting...Anything updated about this issue?
On my Windows 10 system, I solved this intermittent problem by going into Device Manager, finding "Ports (Com & LPT)" and then in that section locating the Arduino 101 labeled Serial Monitor port. Right-click and select "Disable" to disable that port. The, Right-click again and select "Enable". When I go back to the Arduino 101 IDE it now works. Also double check in the Tools menu to make sure the board and the port are still set to the Aruduino 101. This clears up the problems for me every time.
Hi,Just started using the 101. Got the same error from my board when i tried to use the blink example:Flashing is taking longer than expectedTry pressing MASTER_RESET buttonIn my case i downloaded a different version of Intel Curie Boards which was the 1.0.6.(before it was 1.0.7).Hope this works for you guys as well.