Go Down

Topic: Jump on Y axis (Read 7060 times) previous topic - next topic



I got the kit set up, all motors working, everything looks good.

BUT, when I start printing any gcode, after every (let's say around) half a layer, the extruder moves a few millimeters on the Y axis, so it prints like a ladder, which doesn't work of course.

No idea why this would happen, any clues?



Have you adjusted the motor currents on the drivers? The Y stepper might be losing steps.
Prendete quello che dico come un suggerimento, non mi assumo responsabilità di nessun tipo

Go Up