Go Down

Topic: TTYUSB Problem (Read 1 time) previous topic - next topic


Hi everybody !!

I have a strange problem.
I have a program which is talking to arduino by TTYUSB which is working when I have just upload the program to the arduino (with the arduino software), it's working working very well.

But If I reboot, I try to configure the TTYUSO with this :
stty -F /dev/ttyUSB0 cs8 9600 ignbrk -brkint -imaxbel -opost -onlcr -isig -icanon -iexten -echo -echoe -echok -echoctl -echoke noflsh -ixon -crtscts

I try to launch the program : not working :/

I launch screen : screen /dev/ttyUSB0 9600

I stop screen, launch the program : it's working.

What's wrong with my configuration ??


try stty 9600 raw ignbrk < /dev/ttyUSB0

add -hup if you don't want the arduino to reset when you open the port, otherwise wait a second or two after opening before trying to communicate.

Also note that the bootloader runs at 19200 baud.

Go Up