Go Down

Topic: Windows 7 arduino 1.6.13 troubleshooting (Read 732 times) previous topic - next topic

heninsh

Hello !  8)

After updating my arduino software to arduino 1.6.13 my computer can't see arduino boards! I tried to connect Mega2560 and Uno rev3, but nothing. My computer can't see arduino boards and arduino software too.

I have windows 7 ultimate 64 bit.

Why? Any help?

DrAzzy

What version did you have before? I don't think the drivers have changed recently, so the upgrade shouldn't break anything.

What is device manager showing?

Are they official boards or CH340G-based clones? If the latter, do you have the CH340G driver installed?
ATTinyCore for x4/x5/x61/x7/x8/x41/1634/828/x313 megaTinyCore for the megaavr ATtinies - Board Manager:
http://drazzy.com/package_drazzy.com_index.json
ATtiny breakouts, mosfets, awesome prototyping board in my store http://tindie.com/stores/DrAzzy

heninsh

I have 1.6. 8 -10 version. I don't remeber !

Yes, I have a CH340G-based clones! :( I instaled driver for CH3400 and now all is good ! Thank you !  8)

But for previous versions it's works with out driver ! ;)

But now it's allright !  8) Than you again  !

DrAzzy

The mystery is not why you needed to install driver now. The mystery is how it ever worked before!
ATTinyCore for x4/x5/x61/x7/x8/x41/1634/828/x313 megaTinyCore for the megaavr ATtinies - Board Manager:
http://drazzy.com/package_drazzy.com_index.json
ATtiny breakouts, mosfets, awesome prototyping board in my store http://tindie.com/stores/DrAzzy

heninsh

The mystery is not why you needed to install driver now. The mystery is how it ever worked before!
Yes. It worked before wery well so I forget about the drivers! :( :D 

Go Up