Go Down

Topic: interfacing servo withe mega25600 (Read 321 times) previous topic - next topic

NourElHouda

Hi,
I'm a newbie in arduino
and I want to connect my servo to arduino mega25600 just like the picture shown below
I will use PC to power the arduino by connecting it to mega through USB
is it possible and not dangerous,I'm afraid of damaging the arduino
please help it's kind urgent
and thanks

ardy_guy

It's not recommended to power a servo from an Arduino 5V pin: you should use a separate power supply. You should try to find out from the servo datasheet how much current your model of servo is likely to draw.


Go Up