Go Down

Topic: Trouble powering a DC motor with the L293D & arduino UNO (Read 359 times) previous topic - next topic

EranT

Hey all,

My components:

- arduino UNO
- 4.5V DC motor
- L293D chip
- 9V battery
- 3 AA battery pack (4.5V)

I am having trouble getting the motor to run at 4.5V. Right now while connected to  the arduino and the chip it only gets up to around 2.5V.

I am powering the setup using batteries, using the 9V battery to give power to the UNO(Vin) and the chip(pin 16(+V)). The 4.5V battery pack is connected to the chip to power the motor (pin 8 (+Vmotor)).

Thanks in advance,
Eran 

kenwood120s

Right now while connected to  the arduino and the chip it only gets up to around 2.5V.
The 293 has an inherent voltage drop that you can't escape. So stick about 6V into pin 8 as VCC2.

[gumby]I've got my head stuck in the cupboard[/gumby]

MarkT

The L293D and L298 motor drivers both use darlington output stages which lose 2 to 2.5V, making
them rather unsuitable for low voltage use.  MOSFET motor drivers are much better for low voltage.
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up