Go Down

Topic: Severino S3v3 R2 connection to PC (cable question) (Read 282 times) previous topic - next topic

Xsaia

Hi there !

Sorry, my english is poor, i'll try explain how i can.

I found old arduino severino S3v3 R2 w\ bootloaded atmega328P - PO
I'm not load bootloader  in personally, but it (board) works in other construction half year ago (one my frend make this board long ago).

When i'm trying to load sketch from example section to board, i got that message :
"avrdude stk500_getsync not in sync resp 0x30";
Tx led blinks, and led 13 blinks 3 times and nothing go on/

There are 2 ways:

1 ) atmega is dead - but it dont looks so, because, when i push "reset" button, led on the 13 leg blinks 3 times, looks like it still works.

2 ) I make connection cable wrong (i had to do it myself, because original cable was lost).

In severino's user manual typed theese:

Needs a serial cable, with at least 4 pins connected: 2, 3, 4 and 5.

Both connectors are female (on cable), i connected it like theese:

PC - Board
2-2
3-3
4-4 reset
5-5 GND

did i make it correct ?



Go Up