Go Down

Topic: Working with RF transmission (Read 4204 times) previous topic - next topic


Good Morning! I need some help with RF remote control .. how does that work in arduino?  :) tnx for the help ..  :) :)


It works great!  I built one up to transmit button pushes to  receiver with 434 MHz Rx/Tx pair from sparkfun.
Transmitter uses  8 MHz 3.3V promini, 16 button keypad, 3.7V LiPo battery, MAX1811 battery charger chip.  Goes into sleep mode after each button press.
Receiver is also a  promini, but 5V, 16 MHz.
Virtual wire to handle the transfer.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.


well, an arduino is not going to be able to handle the data rates of audio and video. probably not either audio or video. you'd be better off using a premade module for that such as those video baby monitors.

Coding Badly

@weirdo557 ... the post from @claudia3bush is spam.



will be banned because he/she has failed to reply to my request to remove the signature.

Go Up