Go Down

Topic: I have SANYO DENKI type 103-770-3210 (Read 1 time) previous topic - next topic

Robin2

It's well over a week since your last post and I have now forgotten what your problem is.

You posted a program in Reply #12. But as far as I can see you have not provided the wiring diagram that goes with it.

If you were using that program with a RAMPS shield then I don't believe it will work. On my RAMPS shield pins 9 and 8 are not used to control any of the motors.

...R
Two or three hours spent thinking and reading documentation solves most programming problems.

maho


Robin2

#17
Apr 12, 2018, 10:00 am Last Edit: Apr 12, 2018, 10:00 am by Robin2
Thanks anyway.

That seems a strange response.

Have you tried my program with the correct pin references for your RAMPS shield? It will work.

...R
Two or three hours spent thinking and reading documentation solves most programming problems.

Go Up