Go Down

Topic: DC Motors - problems (Read 312 times) previous topic - next topic

gwee

May 02, 2018, 09:56 pm Last Edit: May 02, 2018, 09:59 pm by gwee
Yo guys!
So, Im working on a school project I need to use some DC motors and the L928n driver (ST multiwatt from steletronics/ 16 pins), I didnt find tutorials for this expecific model so can someone tell me how to plug them and witch pins I need to use? Thank you.

Robin2

How does your L298 differ from those in tutorials you have found?

...R
Two or three hours spent thinking and reading documentation solves most programming problems.

MarkT

A little delving found this: https://www.researchgate.net/figure/The-connection-circuitry-of-the-ARDUINO-L298N-with-2-DC-Motors_fig16_315337631 which looks promising.  Note you need 8 diodes on the outputs or you'll risk blowing up the chip.  Its usually easier to use this package in the form of a module
complete with diodes and heatsink and screw terminals.
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]


Go Up