Go Down

Topic: Uploading With Ethernet Shield Attached (Read 792 times) previous topic - next topic

cheeser83

I'm very new to Arduino, so please forgive my ignorance.  But, I have been looking all night for the answer to this question.

I just received my Arduino Ethernet Shield SD and I was able to give it a MAC and IP and I can ping it.  However, when I want to make a slight change to my code, I am unable to upload to the Arduino with my Ethernet Shield attached.  Is this normal?

TerryKing

No this is not normal. Sorry I don't have an idea of what is causing it though.

You might try pushing RESET on the shield before trying the upload??

mrtaylor

Can you upload with the Ethernet shield attached the blink sketch?

mellis


Go Up