Go Down

Topic: not uploading (Read 428 times) previous topic - next topic


it used to upload, but now its not. help! :smiley-cry: 


it used to upload, but now its not. help! :smiley-cry: 

so little information


Please do this:
  • File > Preferences > Show verbose output during: > compilation (uncheck) > upload (check) > OK
  • Sketch > Upload
  • After the upload fails you'll see a button on the right side of the orange bar "Copy error messages". Click that button.
  • Paste the error messages in a reply here USING CODE TAGS (</> button on the toolbar).


Jul 09, 2018, 03:42 am Last Edit: Jul 09, 2018, 03:45 am by larryd
Maybe you burned up the Arduino.
Maybe you are not following the upload sequence properly.
Maybe you have a bad cable.
Maybe you clobbered the bootloader.
Maybe you should try the loopback test.
Maybe you should try some troubleshooting.

No technical PMs.
If you are asked a question, please respond with an answer.
If you are asked for more information, please supply it.
If you need clarification, ask for help.

Go Up