I am new to the world of arduino and electronics
Then you should probably do a LOT of learning before you start modifying a two thousand pound machine that moves at 70 miles per hour and has the potential to kill people. The particular questions you are asking back that up. You should probably not be messing with something that is safety critical until you have at least learned the basics. Really you should be at the expert level for that, but let's at least get past the basics before we do anything that could cause someone to lose a life.
An answer to the question may
Hello guys,I am new to the world of arduino and electronicsI have corolla 2015 with out cruise controlMy project is to make one for itI figured all part of the subject but have single obstacle, is about the electronic speed paddle , it form of two potentiometers of 5 volt power ,each give different value with each degree of foot pressure.I want to hack its cable and make the car think that the paddle is pressed.I thought about arduino PWM and put low pass filter after it but this does not give steady output voltage , and I am afraid that the car will not respond to this.Any help with that ?
Are you sure the factory wiring isn't already there? could you just add the factory controls to the system? lots of the newer vehicles are all the same harness just without the buttons. My truck is completely wired for every extra switch that they make and its as simple and plugging the factory switch in. I wouldn't try to home brew that one man... its not worth your life or someone else.
I am new to the world of arduino and electronics......I figured all part of the subject