here is what im getting in the serial monitor
do you think it was the loop?
I don't have it independently powered yet so I plug it in via the USB do you think I'm getting serial interference or may that be the reason I get the extra data?
USB PinsThe next 2 pins are also used for USB programming. That means that when the Trinket is connected to a computer and in bootloader mode or in the middle of uploading a new program, they are used for sending data to/from the computer! It's possible to share these pins if you are careful. The best use of these pins is as outputs to things like LEDs. We didn't want to keep these pins off the board but we strongly recommend not using them unless you're sure you need them since you might have to disconnect any connections to reprogram the Trinket!
I just ran the code and it works its just really laggy due to the random serial digits
do you think possibly the timmer at the bottom is the one producing the data and lagging up my program?
the blink code ran fine but as I ran my code for the servos they tended to run laggy due to the extra data being transmitted